Good Morning Friends,
I am going to attempt to insert my mortising jig for thoes who are woodworkers on these forums, which will allow you easy mortising with a plungs router on a Greene and Greene Table.

That was an over view of the completed jig before applying it to the table side. Now here is a front view of the set up.

Now finally here is a look at it clamped on the table side so you can use a plunge router to cut the mortise in the breadboard and table side for the Greene and Greene style spline.

Note how the rear is clamped to the table top and the side guides assure perfect lines for the plunges router.

I hope this has been interesting to all who read this post.

Respectfully,

Ralph Jones